HomeNews › CNC line news ›
CNC line news
Basic Operation Procedure Of Laser engraving machine
2014-10-21 21:33:22 Edit by:Linkcnc Hits:
Basic Operation Procedure Of Laser engraving machine
Basic Operation Procedure Of Laser engraving machine
1.Turn On1) Start the water pump and air pump , let the water in laser tube circulate for 3 minutes. 2) Turn on the laser power ,and press “ray testing”button to see if there is ray. 3) Turn on the power of principal machine. 4) Turn on the power of blower fan 5) Operate the transmission file in the computer to start caving. 6) Start the controlling software; make sure that laser head can move left or right. 7) Put work pieces in position,and fix up the focal length(the length see Figure 3 ). For cutting thick materisl,use focus lens of long focal length(2.5”=63.5mm). For accurate engraving,use focus lens of short length(2”=50mm). 2.Turn Off Turn off laser power,principal machine ,blower fan,water pump and air pump in turn. |